Function released and available, but without user manual
You can refer to following information:
(3 steps for make keys:get key info->programming FEM/BDC system->make keys)
1.Make new key with ignition switch(support add spare key and all key lost, all key lost require ISN)
2.Reset FEM/BDC KM(cluster require reset manually)
3.Erase key(after erase the key position become blank position)
4.Backup coding
5.Restore coding
Notes:
1.Backup coding and restore coding can direct operation generally.
2.Add keys, reset KM, erase key must programming FEM/BDC system first
3.in FEM/BDC interface, if 'get key info' the type not support, it will show:customer should use "BMW E-sys software" program FEM/BDC system.then programming FEM/BDC system with VVDI2-BMW
4.When operation on 'programming FEM/BDC system'interface,please don't close this software window until all procedures completed.
5.Programming FEM/BDC system, require soldering and get eeprom.（FEM 95128 chip, BDC 95256 chip）usually there are 2 same chips on the module, please refer to the software diagram, select the correct one.
6.Programming FEM/BDC system,must restore the original eeprom, restore coding.if cannot restore coding or after restore coding assemble FEM/BDC module back to car,but with problem(such as the remote control cannot start the car or the car with window problem)please use "BMW E-sys software" coding for FEM/BDC system
7.If connect power to FEM/BDC module, but the relay keep ringing,please contact technical support for help.usually operation on FEM/BDC should be ok,just need to programming.