Program 2009 Chevrolet HHR key fob with GM Tech2


Success! Have tested Tech 2 clone for 2009 Chevrolet HHR key fob!

 

The detail… Here you go.

Install the GM Tech 2 scan tool
Turn ON the ignition with the engine OFF
Power On the Scan Tool
Hit Enter
Main Menu > F0: DIAGNOSTICS

tech2-Chevrolet-HHR-key-fob-program-1
Vehicle identification – Model Year > (9) 2009

tech2-Chevrolet-HHR-key-fob-program-2
Vehicle identification – Product Type > Passenger Car

tech2-Chevrolet-HHR-key-fob-program-3
Vehicle identification – Product Make > (1) Chevrolet

tech2-Chevrolet-HHR-key-fob-program-4
Vehicle identification – Product Line > A

tech2-Chevrolet-HHR-key-fob-program-5
Diagnostics > F1: Body

tech2-Chevrolet-HHR-key-fob-program-6

tech2-Chevrolet-HHR-key-fob-program-7
Body> F5: Remote Control Door Lock Receiver

tech2-Chevrolet-HHR-key-fob-program-8
Remote Control Door Lock Receiver > F5: Module Setup
tech2-Chevrolet-HHR-key-fob-program-9

Module Setup > F1: Program Key Fobs

tech2-Chevrolet-HHR-key-fob-program-10
Program Key Fobs > F0: Invalidate all key fobs

tech2-Chevrolet-HHR-key-fob-program-11

Instructions:

The procedure will replace the previously programmed key fob with the key fob requiring programming.

 

(Follow Instructions, if it don’t work repeat entire procedure)

tech2-Chevrolet-HHR-key-fob-program-12

tech2-Chevrolet-HHR-key-fob-program-13

tech2-Chevrolet-HHR-key-fob-program-14

tech2-Chevrolet-HHR-key-fob-program-15

All desired key fobs must be present.

When the first key fob is programmed, the module will erase the rest of the slots.

The module will fill slots until [Done] or [Exit] is selected.

 

Note: Only select [Start] once. If the procedure is started again, the control module will start over.

Job’s done!