Ford transit custom 2014 bcm continental 70f3384 +70f3637 perfect read and write to secondhand unit test and perfect.

Greetings from Brazil EMS 3120 clone, works perfect.

It's good for what it is. But it's not perfect, none of them are. Definitely a good starter cloner. Every update it does get better.

I successfully cloned a BMW 8HP gearbox TCU with this tool

Managed to clone a Delphi cem R5F64524. Once I used vvdi to read the password. Impressed.

2016 Chevy Trax 6T40 read on bench , write to car via OBD, worked out perfectly!!!

2011 Citroen ds4 bsi continental Q0X SC667050+95256 perfect read of eeprom and flash and pin code and write

Very capable machine. They are quick to sort the issues. Doesn't do checksums. I do like it though. For the money I don't think it's bad at all. There's an extra or two you might want to buy as well. All in all I'm glad I got one.

My respects to this tool. OBDSTAR simos 18.10 TC1791 by boot. With his adapter MP001

I had a SIMTEC.75.5 and that read ok. Also, an E78 and E83. Both read ok. The E78 has the same processor as the E37.

i did a gpec2a with the 1000 ohm resistor and it worked

As time has gone on, the updates have sorted almost all issues. It has turned into a really good tool. Absolutely love it now though. Only thing really missing is checksum calculation. But saying that, it was never marketed as a programmer but a cloner so to speak. Don't know about VAG EDC17 immo calculation during writing with the OPT areas as it now has these in its list but I have other tools for that. It'll be interesting whats coming in future updates. Would highly recommend it now

it is a good tool in fact cheaper than renault ecu tool or ioterminal

For the money, it's a good tool.

Citroen BSI Q0x sc667050+95256 cloning. Work fine with godiag

I have both foxflash and dc706. dc706 is much easier to get going. the way they are updating the dc706 they will have more coverage in no time

Magneti Marelli fiat 8gmw worked flawlessly be careful to connect to the correct can hi.

I did it with 2017 Jeep renegade GPEC3 I done fine with it, 12v. make sure you are solder GPT1 well.

I have both DC706 and FC200. I now prefer the DC706 as it's fully independent /portable but I also like fc-200.. once additional pcms are addedto dc706, it will be hard to go to fc-200..

I just got mine about two weeks ago. Cloned one computer and it worked. seems more are being added.