How to: read 95320 eeprom from Vw Touran EDC16u34
Device: Carprog full
Adapter: carprog A1+ adapter
FAQs: How to use CarProg with EDC16 VAG
Q: Does CARPROG need external power supply ??
A: Carprog does not need external power supply for that eeprom.
Q: Can I read the memory in circuit or have to desolder ??
To read eeprom, always better to desolder.
Q: Does ECU need 12v??
A: No need 12v on ecu.
Q: Should I have a clip for 8 pin eeprom?
A: Yes i have a clip
Q: Did I locate pin1 correctly?
A: Yes. Pin1 is correct. Try with the eeprom clip. The red wire of the flat cable should be on the pin 1. And desolder.
Q: I use Carprog 8.21 with A4 Adapter.
edc15 24c02 No problem, but with 95320 edc16 no success
Wires connected like on the picture
A: For EDC16 and VAG ECU software you must update A1+:
download update file:
Unzip file to your computer, connect CarProg programmer with A1+ adapter to OBDII connector and make A1+ update.
Note: Carprog A1 vs A1+ adapter
A1+ (A1 PLUS) – new generation ODB2 adapter CarProg use for Volvo dashboard programming and VAG ECU programming.
A1 is not the same adapter like A1+. And A1+ not replace old A1. These are 2 different adapters.
A1+ (A1 PLUS) is a new OBDII adapter with high speed CAN.
Then your Carprog will work with VW, Audi, Seat, Skoda EDC15, EDC16 ECU:
Carprog full is reading VAG EDC16…