Xtool KC501 and X100 Pad3 to add Mercedes Benz Infrared Key via OBD without dismantling anything.
OBD add Mercedes Benz Infrared Key by Xtool KC501 + X100 Pad3 step-by-step below:
To test the two keys before operation, the original key can start the car and the new key can't.
Connect the tablet Wifi first, enter into main menu.
Select Immobilization then "Benz".
Agree the disclaimer.
Click on "Infrared key system".
Click on "Add key".
Click on "OK" after reading the instruction. Please follow to do.
Connect KC501 to Xtool pad.
Insert the original key into EIS.
Wait for 5 seconds and then remove the key from EIS.
Click on "Ok" after finishing the above steps.
Click on "Ok" to select the communication method with EIS.
Click on "Read via OBD".
Click on "Automatic Identify".
Finished reading EIS information, click on "Next".
Repeat the above steps.
Then click on "OK".
Follow the steps to do.
Insert the same original key into the key slot of KC501.
Click on "OK".
Collecting data, it will take about 5- 15 minutes.
Data collection completed.
Insert the original key into EIS and wait for 30 minutes (Maybe you need to pull it out and reinsert it for several times).
Obtained the password successfully from the programmed key.
Choose and input a key location to be generated.
Connect KC501 to the device, insert a new key into KC501 infrared jack.
Key file has been written into new key, click on "OK".
New key has been programmed, can start the car normally.
(Maybe you need to insert and remove the key for several times).
Test if the remotes of new key works. Both keys work.
Job is done.
is too amazing when working together with Xtool X100 Pad Elite (PAD3)