Now make the J-Link connection to Carprog programmer according to the scheme and with the least possible piece of wire that is important
We open the program to go to options / project settings and put it all as the pictures
now file / open data file and select our new firmware
finally we select target / connect / program.
Jlink interface pinout JTAG
J-link to carprog
jtag speed before/after in: auto selection
jtag scan chain information: auto detection
deleted info configuration: ARM7TDMI core ….
device: atmel …..
check core id
Enable target power
Select Target – connect
Select File – open data file…
Select Target and go to Program