OBDSTAR Ford AKL Bypass Alarm Adapter Lincoln Mustang All Keys Lost Harness for X300 DP Plus

Product Description

Use this cable on various Ford models with active alarms without disabling the alarm via keypad first, covering sensors, or various other hoops to jump thru.

It is known to be supported by the OBDSTAR X300 DP Plus, and Smart Pro, but will work with any device that can add keys on the Ford System.
Support Car Models
ECOSPORT 2018-
EDGE 2017-
ESCAPE 2020-2021
ESCORT 2018-
EXPEDITION 2020
EVEREST 2017-
EXPLORER 2017-
F-150 2017-
F-250 2017-
FOCUS 2018-
MUSTANG 2017-
TAURUS 2017-
MONDEO 2017-
FUSION 2017-
RANGER 2017-
AVIATOR 2020
CONTINENTAI 2016-
CORSAIR 2020
MKC2015- MKT
2020 MKX2015-
MKZ2015-
NAUTILUS 2018-
NAVIGATOR 2018

Equipment Overview

1. Diag cable OBD connector(male)
2. P002 adapter
3. Connect P002 connector (female)
4. Connect vehicle OBD diag connector (male)
5. Lock plug
6. Relay plug
7. Battery clip (positive pole)
8. Jumper plug (relay)
9. Jumper plug (fuse blue)
10. Jumper plug (fuse brown)
11. Connect P002 connector TOYOTA-1 female (BENCH)
12. Connect ECU connector TOYOTA-1 female (BENCH)
13. TOYOTA-1 cable 12V power supply (BENCH)

The Ford AKL cable should work with OBDSTAR P002 adapter.
If you need Full set kit, check Item No: SK364
 

Instructions to use the cable:

1.  Disconnect negative battery cable
2. Put the bolt with thumb and turn nut through the negative cable
3. Once negative cable is connected to the bolt put black clamp on negative side of the battery
4. Put red clamp on positive side of the battery
5. Make sure LED is on
6. Read VIN in add key software
7. Flp switch off then back on
8. Tool will then read flash
9. Follow all tool prompts after

1pc x OBDSTAR Ford AKL Adapter