Why do you buy VXDIAG VCX NANO from OBDII365?
VXDIAG VCX NANO for Land Rover and Jaguar Vehicle List:
Step 1: VXManager Installation
Before start to diagnose vehicle, you have to install VX Manager and driver which are stored in the CD-ROM, or you can browse http://www.vxdiag.net to download the newest setup files.
Computer Requirements
Processor: Pentium 4/1.6GHz+.
Memory: 2G Bytes or more.
Hard disk: 40G or more.
Display: Resolution 1024×768 or higher.
Network interfaces: LAN 10/100M or 802.11b/g.
Communication Interface: USB2.0 or USB3.0
Operating System:Windows XP/Vista/Win7/Win8/Win8.1
Setup complete. The shortcut will create on the desktop
Connection device and run VX Manager, The information of device will be displayed in “Device Manager”.
Step 2: VXDIAG Connection
Hardware Connection is two connection mode availabe:
VXDIAG USB Connection
Connect OBDII cable to the vehicle 16pin diagnostic port, and USB cable to the computer.
After device boot complete, the power led will flash, and the buzzer will prompt.
The first time to connect USB cable to the computer, Windows will prompt [Installing device driver] . Windows automatically complete driver installation.
The first time to connect USB cable to the computer, Windows will prompt [Found New Hardware]
Please follow these steps to complete USB driver installation.
After USB driver is successfully installed, PC LED will flashing.
Please make sure the device is connected.
Run VX Manager, The information of device will be displayed in “Device Manager”.
VXDIAG WiFi Connection
Connect OBDII cable to the vehicle 16pin diagnostic port, and computer connect to the device through WiFi.
Then select “Properties” – “Internet Protocol Version 4(TCP/IPv4) “, then “Obtain and IP address automatically” and “Obtain DNS server address automatically”
3.Start VX Manager program,select [Device],then click [Configure], Connection Type select [WLAN],click [Save]
4.Restart VX Manager program,computer have been connected to the device through WiFi
Step 3: Install JLR SDD driver
Please make sure the License has been purchased and updated
Please make sure the device is connected. Run VX Manager.
Please make sure the network is connected or error.
1.VX Manager can manage multiple original diagnosis functions.
2.To use the original factory diagnosis functions, you will need to buy corresponding License and install corresponding vehicle diagnosis driver. For example Installation JLR SDD driver.
Click [Diagnostic Apps] -> [My Apps], then click [JLR SDD] and you will get
a driver installation window.
3.Click [Install],VX Manager will download the newest diagnostic driver from server and install, then you can start to use the original diagnosis function. The installation UI is below:
Update OEM driver (For example Update JLR SDD):
Step 4: VXDIAG Firmware Upgrade
During Upgrade, do not disconnect VXDIAG connected PC