Notes: 1.Please connect ACDP with DME properly, don't cut the power nor pull out the device during the programming, carefully backup the ISN data; 2.Programming is needed for reading the DME ISN, and it may cause risk, please consider before moving ahead; 3. If reading the ISN ended with an error, please use Winkfp or ISTAP to program the DME to work status, then proceed to read ISN again.
Okay, here we go for procedure: Step 1. Please prepare ACDP, OBP+ICP adaptation, PCAN line and DME.
Step 2. Connect the PCAN line correctly to the DME interface as shown.
Step 3. Short the CAN resistor on the OBP + ICP adapter to the "CAN-R Join".
Step 4. Connect the ACDP, OBP+ICP adapter, PCAN line and DME.
Step 5. Connect ACDP, OBP+ICP adapter, interface board and DME.
Run Yanhua ACDP software on mobile phone or PC
Look at Mini ACDP software menu below, click on "BMW".
Click on "DME ISN".
Click on "OBD / CAN Mode Read / Write ISN".
Click on "Read MSD80 / MSD802 DME ISN (Support E Chassis)".
Here are function menu: ECU Info. Read ISN /PSW Backup FLASH Restore FLASH Upgrade program ECU Reset Modify VIN.
Go on operating by following the on-screen instruction.
Next is to write MSD802 DME ISN with Yanhua ACDP Mini With one extra MSD802 DME ISN Interface Board Set, ACDP Mini can write MSD802