Supports following type of keys:
Dealer codes not required. Fast calculations.
Connect network to fast calculate!
Buy AKL license get whole year AKL free online calculation.
Use H0440C to collect data and generate with K518/KH100+ directly.
To add an original key, please go to:"Generate emergency key";
To do all key lost, please go to:"Generate smart key"
Operation process is basiclly the same in these two cases!
K518: Special functions-->Key settings-->FT smart key-->8A
KH100: Special function-->FT smart key-->8A-->"Generate Emergency/Smart Key"
Please note: this H0440C online AKL annual license is seperate from K518 update.
Program all proximity keys lost for new Toyota 2019-2021 with Lonsdor K518ISE. The same procedure goes to new Rav4, Highlander, Avalon, Lexus ES, UX, LS etc. To do this job you must have Lonsdor dedicated smart keys. No need NASTF code for 24-48 hours use and $60-$100 subscription. No need new OEM key for $150.
What you need are:
Lonsdor k518ise/k518s or kh100+
Lonsdor dedicated Toyota key and yearly AKL license subscription for Toyota
The authorization also covers Toyota RAV4, Highlander, Avalon, Lexus ES, UX, LS, GX series.
In vehicle make sure you have a strong wifi signal available either a hotspot to something nearby
Also make sure you have authorization installed.
First thing we going to do is disassemble the lonsdor H0440c/H0410c key
Remove emergency key first
Remove pcb board to begin programming
If you got the pcb separately, ignore this step.
Use backside for best signal and reception
Set up wifi setting
Connect to strong wifi
Go to main menu, select Special Functions- Key settings- FT smart key- 8A- Generate smart key
This function requires internet connection
K518 ask us to put smart key into the card slot
Select frequency 314.35
It is going to download the information from the car
Take all keys outside the vehicle, press START button, put H0440C key close to the button to begin vehicle data transfer to PCB. wait for about 10s until indicator pulses regular for 10 seconds straight, if the key indicator does not flash, press Start button once again
At this point, if the lonsdor failed to proceed choose another frequency and repeat the previous process
Return pcb to coil and continue
Lonsdor k518 is downloading that information from the card
Select don’t have working key
Now the key can start car, but remote does not work, continue to the next step
Go back to Special functions- Key settings- FT smart key- 8A- Modify remote count value
This function is only useful if you’ve already generated a key that doesn’t fully function for the vehicle
Put the smart key generated online into the card slot
Add 400 to the value shown and then modify
The value should be 1406
It’s been modified.
Tes the key, still not function, it is normal.
We will do the modification again
Modifying made simple
The numbers in sequence range from 1-F
When adding increments of 400 keep in min 4+4=8, but 8+4=C
Here is the number sequence without the testing and retries involved.1006 >1406 > 1806 > 1C06 > 2006 >2406 >2806 >2C06 > 3006 > 3406 > 3806. to clarify, the last 2 numbers are just to be copied as presented. the Lonsdor k518 machine automatically adjusts them each time it’s read, and the end result is unpredictable. just think of the numbers as - 10 – (XX), where the x’s are just to be copied and just follow the rest of the sequence follows the above pattern adding “0400” each time.
Modify value again, this time, modify value 3845
Remote is working.
Earthing is working.
Once vehicle responds to remote, you have found the correct modification value.
Be sure to test all button and proximity functions before finishing.